I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
The battery service failed by Bluetooth BQB certification,
NRF52832 with nRF5_SDK_17.0.2 keil V5.27
My config as below:
static void bas_init(void) { ret_code_t err_code;...
The zephyr peripheral hr example us altered create a custom GATT service with a 128 bit BT uuid instead of a 16 bit bt number. I tried the following which does not trigger...
Zephyr Eddystone example is connectable after power on of nrf52833 board. But after disconnect it becomes non connectable. How to fix it? And how to change advertisement interval...
I am evaluating a thingy:91 for an asset tracker project, so far a fantastic device. I followed the getting started guide and different online videos.
I have never been...
Hello all,
I am using sdk 16, trying to make a simple interrupt from pin 19.. I keep getting error code :- on this line nrfx_gpiote_in_init(19, &in_config, in_pin_handler...
Hello,
I decided to update the SDK from version 1.9.1 to version 2.2.0 but I countered the following issue:
Could be oldest compiler path?
Thank you in advance....
I've developing an application for the nRF52833 that uses the v7.2.0 s140 Soft Device and the secure BLE DFU bootloader.
I'm able to compile the bootloader (taken from...
Walkie-Talkie example works (add CONFIG_WALKIE_TALKIE_DEMO=y to prj.conf), but it is not bidirectional. I can only hear sounds from gateway's OB microphone.
I also tried...
Hello, I'm trying to get an analog comparator working on the nrf52833DK. I am using NRF Connect SDK version 2.2.0. I have the following code:
At the moment when I would...
I've set my Board Roots variable:
The folder specified is root to my board definitions:
I've closed out VS Code and restarted it a couple of times. However, it refuses...
I cannot find anywhere how to make a physical connection from the nRF5340 to the PC in order to enable logging from the uart. There is information on baud rates etc, but I...
Hello!
I am working with a BLE central device running on an nrf52832 using the S132 softdevice and sdk version 15.2.0
I need to pull the full device name out of the scan...