hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hi,
I have been looking into the passkey for BLE connection but didn't found any clear documentation or any example on this. If we have one central and one peripheral...
Hello, I am a student who wants to improve myself in the field of nrf and this is my first question. I am using NRF24LE1. I can run Timer0 and Timer1 separately in main function...
Hi,
I found a topic that discuss the LPUART power consumption.
In this discussion, it is mentioned that the power consumption of LPUART was introduce by GPIOTE IN, which...
Hi! I've been trying to get the QSPI peripheral working with my hardware's external flash (up until now I've just been bit-bashing)
I've got two main issues...
First,...
Hi.
I use 5340 + spim 32M (nrfx driver) + ncs 2.0.2 + LVGL library. (display driver ic is RM69090)
I try to communicate display with spim and success work. but refresh...
hi devzone
I tried connecting nrf52832 dk board - debug out to bluetooth module nrf52832.
I refer to this picture.
at fisrt, it was successfully to connect dk...
Hi Nordic,
I have got an nRF52833 DK PCA10100. In SDK17.1.0, there are few examples about nRF52833, for example, what should I do if I want to use examples\ble_central\ble_app_multilink_central...
Hello,
I attached LIS2DS12 accelerometer sensor driver to the nrf5340 board, and I am trying to do (1) i2c access and (2) single tap interrupt handling (the sensor activates...
Are there any samples that show how to use the nRF PPI subsystem with nRF Connect?
My task is to configure the SAADC to take samples at 200hz, collect the samples into BLE...
Hello to the community!
I have two nRF52832 sensor nodes and aim to implement synchronized sampling of all sensors, including synchronization between sensors of the two...
Hello,
I've implemented DFU OTA updates and it works using the nRF Connect app. If I wanted to do this from a custom app from my phone, how would I approach it?
I've...
Hello,
I'm using the nRF Connect SDK v1.9.0 and a nRF5340 on a custom board.
I want to use MCUBoot as a primary bootloader. On the development kit, the UART connecting...
