hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
During the software testing process, our device is connected to the rtt viewer for testing. At present, a problem is found during the test: sometimes the test engineer suddenly...
Can a single sdk_config file that has all possible macros definitions to use with an SDK
(1) be provided ?
(2) so that an identical sdk_config file be inserted in all...
Hello,
There is a missing #ifdef check on the following line of SDK Zephyr at the latest version v3.1.99-ncs1:
https://github.com/nrfconnect/sdk-zephyr/blob/98bc3a7a6b3917ce5a058e7a7271d3036edffb88...
I changed Kconfig of u-blox board template and something is going wrong in create_nordic_project.py when I tried to create project in Segger Embedded Studio from changed template...
hi support team,
there is one question feedback from customer, device（832）is sending data to mobile device, however this connection is disconnected （however there would...
Hello,
very early evaluation question, the 52832 has NFC-A. Is a mobile phone capable of reading from this device (some arbitrary user data) ? Now I've started looking into...
Dear,
- nRF connect SDK 1.9.1
- nRF5340 DK
We use 5340 spi to control an adc chip. The sample rate we need is 1kHz, so we use k_timer to produce a 1ms timer.
However...
The issue is as stated in the title. The 'Select Device' column says "Connect a Nordic development kit to your computer" when the Power Profiler is NOT plugged in. This imediately...
Can someone help me with a Zephyr compiled blinky hex file please?
My Hardware is a loose standing module setup similar to NRF52833 DK. (same led_0)
NRF5 Sdk hex file...
I am using fstorage to store some data at three location in flash.
but it is hanging at wait_for_flash_ready function when mobile phone is connected through BLE.
Please...
Hi everyone, I am quite newbee to nRF5340 and nRF ecosystem. Anyway, my goal is to talk with 3rd party application to receive positioning data over bluetooth and then I have...
Working with nRF52840 and nRF Connect SDK v2.1.0., whenever I enable MCUboot in the project configuration, the reset pin gets enabled on the next flash. I believe this has...
