Hi
Does anyone know a CE—certified module based on the nRF24LU1+? Ideally, it should have an SMA connector, but any kind of antenna would be fine.
There are many modules...
I am running peripheral example radio test example on PCA10001(part of nRF51822 Evaluation Kit). using nordic sdk v7.
I am using mincicom on linux at baudrate of 38400...
Hello!
I am trying to get windows phone work with nrf_uart example on nrf51 dk board (pca10028).
I am using SDK 9.0 with S110 softdevice ver. 8.0.0.
I was using examples...
Hi
I met a problem when I use my new board,I found that the example in the peripheral folder in SDK can run correctlly,but the the example in the ble_peripheral folder...
Hi,
I am trying to use the PORT event to trigger interrupts when a button is toggled, i.e. both on LoToHi and HiToLo.
To my understanding PORT events are generated by...
I am running Windows 7 Pro SP 1 64 bit and have gong through the tools installation procedure, in particular running nRFTools_7_7_0_Installer.exe. This ran the J-Link V5.02...
I am very familiar with the arduino side but the BLE is brand new to me. I was wondering if I can use P0.00 and P0.01 to talk to the arduino and if its possible how exactly...
In the Example "ble_app_cts_c_s132_pca10040 " messages are send to the UART output, by default the UART Hardware Flow control is active. I would like to disable the Hardware...
We have designed a product using Nordic's nRF51822 and will be selling into Korea and Taiwan market.
Recently, there is a new requirement for us to provide antenna radiated...
Hi
I started form the lbs example to build my application. I have now the following problem:
apparently the button_event_handler is only triggered when the device is connected...
Hi,
I have searched the forum, but still I cannot find answer to my question. I designed my custom board for nRF51422 and want to work with ANT (softdevice 210) (I have...
Hello everyone
i want to create button fucntion press the button for 3 seconds and then it has to start advertsing but i have excuted the button fucntion but it si showing...
I'm a new at BLE. So, as I know from bluetooth spec v 4.1 there is a opportunity to establish multiple connections to the same peripheral device from several central devices...
I want to send 500 bytes(chunks of data) for specific event so when I get new 500 bytes from sensor firmware should send all of those bytes over BLE service in proper order...
This thread provides some references for those of us who need to have firmware that runs on multiple releases, but don't necessarily know what revisions are in the field....
Hello,
We have the following Problem to solve in general:
A device should control the exhaust system in a vehicle.
This device needs to retreive the engine RPM using a...
Hi
I have a brief question to which I'm not able to find a clear response: When the SD send a notification of a change in a service value, this notification has a confirmation...
I have ASUS ZenPad 10 with Android 5.0.2,
BLE device on nRF51, S110 SDK9 with fixed passkey and encrypted characteristics with following settings
#define SEC_PARAM_BOND...
Hello,
As far as I can tell, the NUS app sends a signed char of value -127 to 127 in decimal. Is there a way to use the stock UART application to send an unsigned byte...
