GOAL: To send one 20-byte data packet from an Android Galaxy S5 to nrf51822 and send three 20-byte packets from the nrf51822 to the S5 in a single connection interval of 10...
Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hi Dev team,
I was looking through the documentation of PMIC from the Thingy91 User Guide and I saw that the PMIC in Thingy91 can be used for battery charging (" The PMIC...
Hi,
I do not get any neighboring cells reported using this command. Is one particular state required to receive information regarding neighboring cells?
-Marius
Hello world :-)
I am writing I2C temperature sensor driver over `i2c0` working in `twi` mode in Zephyr with my custom `dts` board configuration and this pops up on the console...
The current platform of the AOA contains 12 antennas multiplexed into one 52833 module
The distance between each antenna is small, hence the angle delta that can be detected...
Hi Nordic Support Team,
It can connect and read the Service UUID and Characteristics UUID, but when I am trying to do the DFU update on the iOS (iOS 14.5) but it will disconnect...
Hi,
I am developing the system where I am sending the data of three sensors to the server using MQTT. For the above development, I used two microcontrollers one to collect...
Hi Nordic Team,
I would like to share with you a minor challenge that we are facing to use the nRF52840 dongle with a Zigbee Mesh network and issuing a serial communication...
Hello,
Does anybody know where I'll be able to find an EAGLE library for the nRF52840 CKAA chip (the WLCSP-93 package)? I've looked around and all other dev boards that...
Hi,
I'm having doubts about whether to use NUS or OTS to transfer 500 bytes of data from the peripheral device to the smartphone. Regarding OTS, I've tried using the ble_ots_central...
Hello.
I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0) as a central and Android device (Bluetooth 4.2) as an advertisement.
During development, I was wondering...
Hello,
Following is my hardware and firmware setup.
Thread BR:
PCA10100 v1.0.0 connected over J-Link microUSB port to RPi 3B+
SDK v4.1.0
Thread Node:
PCA10100...
