In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
I tested BLE mesh example. I have 4 boards 1 nRf52832 and 3 nRF 52840
1 board as client(nRf52832)
1 board as Provisioner(nRF52840)
2 board as server(nRF52840)
i loaded...
Hello
I'm trying to use the secure bootloader from the SDK Examples. It worked all fine with downloading and the example package.
But if I try to make my own application...
I am trying to come up with a BLE solution for a Linux based audio project. The Linux target would function as a hardware appliance and as such would appear as a BLE peripheral...
Hello Community,
I have been trying to avoid asking this question here (it may be trivial) but I guess the answer will help other people as well.
In the ATT_MTU throughput...
I was on Instagram, and I won a green nordic 52 from Nordic. I got it, became frustrated because I didn't have a JTAG debugger, and flashed espruino onto it with nRF toolbox...
Hello,
I have a question regarding the correct way/good practice of programming with the use of SPI. I am using SDK 15.0.0.
I've written some code in a source file peripheral...
hi.........
i am using nrf52832 and segger 15.2
i am merging the two programs in order to send the data through ble to phone(uart app)
i am getting the error
undefined...
hi !
I have start to program the SPI example to communicate with the BMP280 from Bosch and i have seen good results so i'm tried to implement the code over ble_app_uart...
hi..........
i want to put my peripheral device in sleep mode ? how to do that?
i tried this one , its shows error
err_code= sd_power_system_off();
APP_ERROR_CHECK...
Dear Nordic Team,
Thanks for supporting.
Currently i am trying to work with multilink central in NUS_C example based on ble_app_multilink_central. The edited code was...