Hi...
Can anybody help me to run ble_peripheral example (ble_app_hrs for S130). I have build and load the code successfully but cant see the advertisement. But while debugging...
I am working with the nRF8001, and I'd like to create a services.h file that will let me broadcast battery level and as well as allow temperature to be read by a peer.
...
Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
I am using timer 3 as a counter for my capacitor discharge time. Currently, the value of is always problematic because it shows with too many deviation values sometimes...
Hello,
Is there any user manual to the nRF Connect for Android? I guess it is quite simple tool, but I am complete beginner in the BLE and would appreciate some description...
Hello All,
Currently we have a nRF52832 firmware .hex file for mass production.
And we use "nrf connect - programmer" to firmware programming without any problem.
...
Hi!
I'm updating to SDK v1.7.1 and I am looking at the changes in LwM2M Carrier Library v0.20.1. I was previously using LwM2M Carrier LIbrary v0.10.2
The big change is...
Hello,
I'm trying to install circuitpython onto an nrf52833 dk board, and am running into a fair amount of trouble.
Wondering if anyone can provide a guide on the explicit...
Hello,
I am trying to port the 51822 project to 52833. I am testing the port to 52832 temporarily.
The 51822 project is a commercial product.
SDK – 17.1.0 SD-S132, PCA10040...
Hi ,
I check the datatsheet "nRF21540_PS_v1.0.pdf" but I confuse on page 22 "TX_Gain initialized with POUTA_PROD (20 dBm +/- 0.5 dB)".
Which one is correct??
1: Tx gain...
I’m trying to use the Power Profiler app v3.2.0 under nRFConnect for Desktop v3.9.1 with a PPK 1 attached to an nRF52 DK board (containing the 52832 processor), but am having...
Hello, i'm having trouble with my new Board Nrf5340, i cannot detect the board to my PC.
I connected with micro USB and when i'm going to the device manager, i'm not seeing...
Problem:
Tried to compile (west build --board nr52dk_nr52832) the C:\nRF\v1.7.1\nrf\samples\peripheral\lpuart project but it failed to compile. I discovered this after updating...
Hello All,
I am new to use Segger Embedded Studio and NINA-B406 module. I have installed Segger Embedded Studio V5.50d and EVK of NINA-B406 module having nrf52833 SoC. ...
Hello All,
I have taken usbd_ble_uart_freertos example and modified it for USB MIDI example (taken from Github) for nRF5 SDK and modified it to use nRF52833 SoC.
I am...
