Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
I have two custom PCBs, each of which has a microcontroller and an nrf24L01+. Everything related to the transceiver in the designs are complete duplicates (with the exception...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Hello,
We are looking for the ways using which we can program the nrf52840 SoC without using PDK. We want to set up an automatic programming jig and for that using the PDK...
Hi,
I'm trying to setup my nRF52832 to advertise using a RESOLVABLE RANDOM PRIVATE address and to obtain this I have used the sd_ble_gap_privacy_set() before starting advertising...
Hello,
I was able to build the example project MPU6050 from Github with SDK 16. However, I used Putty to connect to the board (PCA10056) with baudrate of 115200 on COM3...
Hi, I am using nrf52832 with SDK 15.2.0 and nrf 52 dev board. I want change advertising interval in run time so I call a function with the interval as the parameter change_adv_interval...
Hi
I am using nRF52832 for my application. I need RTC functionality for counting seconds,minutes, hours and days to include timestamp for my data packets.
Can the RTC...
HI.
I Want DFU In Application So I Want to Write DFU Data In Internal Flash. Device configure has total 3 links... 2 -Pheriphiral Link and 1 Central Link use in my project...
Hello,
I am trying to decrease current consumption as much as possible. I am using ble_app_uart example, sdk 16.0.0, s112 v7.0.1, nrf52810. when I edit
to
...
Hi.
We have developed custom device based on nRF9160 and we are facing a some problems related with GPS fixing. Sometimes it takes hours to fix, even we are getting signal...
Hi,
I have blocking TWI operation in app_timer callback to read fifo from accelerometer. It works just fine but I want to make it non-blocking to decrease current consumption...
Goodmorning,
we are looking for a development kit to test the transmission for the following purpose. We need a system with one receiver and some transmitters (up to 5)...
Hi
I want to share how quickly start developing for NRF9160 with CLion, just in case someone tried and struggled, or someone really annoyed with Segger development experience...
Hi,
I am using nRF52 as a twi mater to read some data from a touch sensor, I want to perform below operation:
twi start
twi rx register_a for few bytes
repeated...
