I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
It is possible to run easily a SoftDevice stack (e.g. S110) on nRF51422 using an accurate 16MHz external clock reference for HFCLK instead of an external 16 MHz crystal oscillator...
Hi!
I am working on creating a Low Power mesh network and am trying to decide which communication protocol I should use with the NRF52840. There are no nodes in the network...
Hello,
I'm using NCS 2.0.1 on a nRF5340 board.
Currently I have some troubles with getting a response if I try to write a BLE characteristic from an iOS app. The write...
Hello, I am trying to disable using uart for console use Kconfig.
I am using sdk v2.0.2 (VSCode + nrf connect extension)
It works and the software works as expected. After...
Hi,
I would like to know how I can get the connection parameter in nrf connect for desktop. I want to assign the same parameter for our pc-ble-driver-py program.
Good day to all
I am at the final stages of developing a program for collecting sensor information from a UART and publishing it onto a mqtt server. Currently the device...
Hi All,
I am using nRF5_SDK_17.1.0
while building SDK example project uder the below path with SES
..\nRF5_SDK_17.1.0_ddde560\examples\dfu\secure_bootloader\pca10100_s140_ble...
Hey!
Would it be possible to use I2C and SPI simultaneously on the nRF5340? I'm using I2C/TWI for sensor data (optical based) and SPI for a DAC - need both of them operating...
Hello,
I'm doing a few power consumption tests on the nrf9160 DK with NB-IoT for a battery powered application. PSM mode works as expected but I measured a current drain...
Hello, I am looking to cheaply flash a nrf5340. This will most likely be a one-time thing, so I don't want to invest in a J-Link device.
I have an ST-LINK clone though and...
Hello Everyone,
I need help in the integration of MPU6050 with nRF52840. I know inside SDK one example is present but it worked with nRF52832DK. when I tried to build it...
Hi!
I am attempting to configure a nrf5340 dk as a central to receive BLE notifications. The code is based on the central_hr sample.
The notifications i am attempting...
I'm like 99% certain this isn't possible but has anyone tried running VS Code Server with the nRF Connect SDK?
https://code.visualstudio.com/docs/remote/vscode-server Compiling...
Hi,
1.Mode B prevents RF9160 from entering low power consumption. How to disconnect RTT from nRF9160 module in mode B
2. In normal mode A, disconnect RTT from the computer...
