I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
It is possible to run easily a SoftDevice stack (e.g. S110) on nRF51422 using an accurate 16MHz external clock reference for HFCLK instead of an external 16 MHz crystal oscillator...
Hi,
I'm trying to implement the FATFS example with the SD Card access into the Mesh DFU example. Setup is SES v5.44, SDK 17.0.2, Mesh SDK 5.0.0 and S140.
After the...
Hi,
I have been looking into the passkey for BLE connection but didn't found any clear documentation or any example on this. If we have one central and one peripheral...
Hello, I am a student who wants to improve myself in the field of nrf and this is my first question. I am using NRF24LE1. I can run Timer0 and Timer1 separately in main function...
Hi,
I found a topic that discuss the LPUART power consumption.
In this discussion, it is mentioned that the power consumption of LPUART was introduce by GPIOTE IN, which...
Hi! I've been trying to get the QSPI peripheral working with my hardware's external flash (up until now I've just been bit-bashing)
I've got two main issues...
First,...
Hi.
I use 5340 + spim 32M (nrfx driver) + ncs 2.0.2 + LVGL library. (display driver ic is RM69090)
I try to communicate display with spim and success work. but refresh...
hi devzone
I tried connecting nrf52832 dk board - debug out to bluetooth module nrf52832.
I refer to this picture.
at fisrt, it was successfully to connect dk...
Hi Nordic,
I have got an nRF52833 DK PCA10100. In SDK17.1.0, there are few examples about nRF52833, for example, what should I do if I want to use examples\ble_central\ble_app_multilink_central...
Hello,
I attached LIS2DS12 accelerometer sensor driver to the nrf5340 board, and I am trying to do (1) i2c access and (2) single tap interrupt handling (the sensor activates...
Are there any samples that show how to use the nRF PPI subsystem with nRF Connect?
My task is to configure the SAADC to take samples at 200hz, collect the samples into BLE...
Hello to the community!
I have two nRF52832 sensor nodes and aim to implement synchronized sampling of all sensors, including synchronization between sensors of the two...
Hello,
I've implemented DFU OTA updates and it works using the nRF Connect app. If I wanted to do this from a custom app from my phone, how would I approach it?
I've...
