Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I have enabled UART_1 but cant seem to send any data or receive any, I have hooked it up to logic analyser and cant see any trx data coming from the board.
If i set my...
Hi
I am trying to modify the MCUboot image to meet the requirements of the project one of the rquirements is to boot the application directly from the secondary partition...
Hi, my region does not support LTE-M or NB-IoT. I would like to prototype an asset tracker with GNSS only. To my understanding, i will be able to retrieve GNSS location data...
Hi, I recently I have implemented the Time Model for the nRF5 SDK for Mesh and happy to share my implementation here: https://github.com/hashing-cell/BLE_Mesh_Time_model ...
Hi
We have a project where 1 central shall be connected to 1-7 peripherals. The central sends a short start/stop message to the peripheral then the peripheral starts to...
I have enabled advertising fast and slow mode. But changing from fast to slow mode is almost at same time. How to configure for changing advertising mode slowly?
The following...
Hello,
I am using the 9160 to send MQTT messages which are received on AWS. I am provisioning the devices by creating a thing on AWS, getting the certificates, and loading...
I have a problem that my nRF52840 Central cannot discover one of the my nRF52840 Peripheral sensor services. With the phone I have no problem. Also other services are detected...
Hi team,
I am using NRF52833 DK with PCA10100 on it and s140 soft device version..
While I am merging the ble_app_uart example with ble_app_multiperipheral example, the...
Hi, I'm currently developing an automatic connection BLE system.
I'm using nRF52840 DK with nRF Connect SDK and S140 SoftDevice.
In fact, there exist already other...
Hi Nordic,
I would like to understand the philosophy behind the nRF9160 DK acting as a debugger. I recover my thinky:91 connecting the 10 pin flat cable from thingy:91...
I was using nrfjprog successfully about a year ago before this evaluation was suspended. When I now try it fails.
```
nrfjprog --log --program build/zephyr/merged.hex...
Hello,
I'm trying to writte a sensordriver for the nuvoton NAU7802 ADC in Zephyr using the drivers/sensor API. Here are the most important (I believe) parts of my code:...
