I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
Hi,
I was suddenly getting a EPERM error on nRF Connect for Desktop. I have uninstalled and re-installed. I get same error, plus Jlink now is showing a error at installation...
Hi,
We're developing a device based on the nrf52840.
We want to read LC3-encoded files on the filesystem, decode them, then send the data to the i2s peripheral. However...
I measure the quiescent current of Thingy:91X (v1.0.0) with enabled BLE connectivity bridge.
To my surprise, this seems to be significant larger than that of a Thingy:91...
Hi,
I have following problem:
I try to synchronize specific event let's say every three seconds. My simple test is just looping date_time_now() and taking modulus out...
I am attempting to create an SPI communication to an ancillary circuit through an intermediary board and the nRF52840 USB dongle. If I start with the zephyr sample spi_flash...
Hi, I am starting from the following example: "Bluetooth Low Energy UART service sample", sdk version v2.6.0 I am trying to add a custom board (using VSCode NRF CONNECT extension...
ncs v2.9.0
peripheral_uart (nRF52840) modified code
central_uart (nRF52832) unmodified code
using power monitor for current consumption
When I send the packet from...
I want to update some data stored in UICR CUSTOMER area on an nrf52832.
Code to do this works fine, as long as the areas are already erased (0xFFFFFFFF).
However, if they...
Hi,
I'm doing a test with a test harness. An error occurs in test case TC-CNET-4.16. I would like to know how to solve this problem.
environment
・TH raspberry pi 4 Version...
Hello everyone,
I am currently facing the issue that migrating to NCS 2.9.0 is not possible as I get the following compile error:
Someone else had the same issue: Unfortunately...
