I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, I am developing using nrf52832 and st7735s.
Successfully displayed the lcd screen using the code in \examples\peripheral\gfx
However, when screen clear, text_8print...
We are trying to send the ECG data to phone app via device that has the MAXIM AFE and nrf5340. The raw values need to be sent whcih are captured at 512 Hz from the AFE. We...
Hello.I'm presently working in door sensor project in nrf52840.To use low power mode in sensor,I need some details,documents or SDK's regarding power management for further...
Hi All:
Now we are delveloping BLE Mesh using nrf52840 sdk( v5.0.0) and use light_switch example.
It is important for us to send 10 bytes of message from nrf mesh app...
Hi, all
I'm using I'm using nRF52840, s140.. pca10056.
I added a spi to the ble_app_uart example.
However, the handler is not called after the nrf_drv_spi_transfer...
Hello, I am trying to make a sinusoidal by using the PWM module with an interrupt handler.
The thing is, the signal looked perfect from the development kit. However, when...
Hi there. I've designed a PCB around the NRF52833-QDAA, mostly following the variation 2 sample layout. Upon assembling my board, I was able to flash it exactly one time using...
I've just built the slm_lte_modem application using SDK 2.2.0. I've also programmed modem firmware 1.3.4 into the device. I have access t the AT command set and most of them...
Hi Sirs,
in nRF5340, is it doable for to adjust the power index of different channels of BLE_1M or 2M, in terms of SW code (if there is then where? or NVRAM like setting...
Hi,
after the manual installation the Quick Setup of nRF Connect for VS Code says
that GNUARMEMB_TOOLCHAIN_PATH and ZEPHYR_TOOLCHAIN_VARIANT environment variables are...
Hi,
I'm using nrf9160dk and i want to run HTTPS_CLIENT example to send some ping.
when i run the HTTPS_CLIENT I'm getting error:- " getaddrinfo() failed, err 0 "
i haven...
This question is all about massaging CMake I guess, but I cannot get any clear answers from the CMake documentation. Here is my problem:
I have a NCS based project that...
Hello,
I'm using the nRF52832 product, nRF5_SDK_15.3.0_59ac345, and the android S21 mobile phone as a back-end system. I'm working on ble_app_bps, ble_app_gls, and ble_app_hrs...
Hello everyone, I'm using the secure_bootloader example to load the application into my device. I need to detect bootloader progress, can anyone tell me how? I would like...