Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
I tried to redefine weak app_error_fault_handler by custom one (nRF5 SDK for Thread and Zigbee v2.0.0, Segger Embedded Studio), according to https://infocenter.nordicsemi...
Hello, I am currently in the micro selection process for a project looking to go to production that requires the capturing of an image and the sending of that image over Bluetooth...
Small bug report: MAX and MIN are defined in param.h. nordic_common.h redefines these macros which creates warnings if param.h is also included. nordic_common.h should check...
Hi , everyone
i want nRF52840 to acts as central and peripheral simultaneously . how can i achieve this ? i have seen in website nRF52840 can concurrent upto 20 link (multilink...
Hi,
how to connect multiple peripheral to single central using app , i wan to send the data from central to multiple peripheral and peripheral will also want to send the...
Hi, I'm currently developping my first app in java.
This app requires a direct connection with my BL652, which doesn' t accept any kind of pairing option. That being said...
I'm migrating a project from SDK 14.2.0 to SDK 15.3.0. I use gcc. I have three advertising modes and the first of them is working fine. For the second one, the same
ble_advertising_init_t...
Hello,everyone
I want to add dfu service in UART example ,but when I tried to allocate the RAM,Debug terminal shows nothing,Then I set the breakpoint in nrf_sdh_ble.c and...
I am using Nordic SDK 15.3 and nRF52840 to interface to a NAND flash TC58CVG2S0HRAIG. I'm new with the SDK and I have little experience with the SPI / SPIM functions. I started...
Hi guys,
I use SDK14.2 (i can switch to SDK15.0 if it makes any differences) and would want to integrate FreeRTOS to my existing project. I have tried the FreeRTOS example...
Hello,
I need to measure battery on my nrf52 beacon. My input voltage is 4*AA batteries(each 1.2V so in total 4.8V). The schematic provided by the hardware developer is...
Hi
Am trying to implement the secure bootloader for the nrf52840 for Dongle,I have gone through the existing example for nrf52382 but am unable to find any example for nrf52840...
