In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
hi everyone.now i am developing a project with nrf51822.i am using the PCA10000 dongle to see some information of advertising packages. i moved out and pluged in the PCA10001...
I'm attempting to load the ant-fs reference design to two different nrf51422 evaluation boards. The application builds successfully but I am having difficulties loading it...
Hi
my application is a 9-axis battery driven motion sensor with a data rate about 144 bit per packet at 1000Hz i have to transmit over air. Low latency (<10ms) is extremely...
Hi,
is there any Example to use the UART ?
I need an monitor while the application is running, is the UART COM Port the right one for this?
Is there an example with...
I need a mutex and I found this information at the ARM site: infocenter.arm.com/.../index.jsp
Is there anything I should be aware of in using this technique to implement...
I have a central device , that acting as a gatt server. the service is customize, and 128bit- primary serivice UUID ,its characteristics' UUIDs(128bit) are all known, how...
How are the four RAM banks divided up in the nRF51822? Is it an even split of the 16K total RAM (i.e. 4K per block)?
Furthermore, can I expect strange results if I turn...
Hello, sirs.
My question is how to configure clock in gazell protocol on nRF51822
I look at the example gzp_dynamic_pairing but that does not have a code part of modifying...
I want to stream data continuously from a sensor to a host, using BLE.
Using the nRF8001, I have defined a GATT server, with notification.
From an Android phone, I open...
Can the nRF51822 handle more than one connection at a time? I suspect that the answer 'no' based on some indicators, but it'd be good for me to get a conclusive answer. Thanks...
