Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Hello Nordic team,
In my BLE application, I would like to initially scan for a certain peripheral using advertised UUIDs (i.e. using UUID filter). Then, when the application...
Hi! I can't figure out how to use the profile class to change the monitored sensors dynamically. Those. I am passing to the nRF52840 DK the number of the sensor I want to...
Hello,
I created a BLE Peripheral (ble_custom_auth) that has a custom service. I also create a BLE Central (scan_adv) that scans for that service UUID in devices, once found...
Hello Nordic team,
Our team deveopment a BLE NUS project, we use nrf5340 as BLE peripheral and nrf52840 dongle as BLE central. (NCS v1.8.0)
We use nrf52840 dongle transfer...
I have an nRF9160 custom board in development. Parts on the board turn out to be Revision 1 (B0) with 1.1.0 modem FW installed. Original application code was done with nRFConnect...
Hello nordic team,
I am trying to build up a mesh network using openthread and reading some sensor data via i2c and broadcasting them in the network. I have code that broadcasts...
Hello,
let me share my code and I am requesting you to review it.
Here, I am sending each character by character to the keys_send function, for example,
ex: AB23CD ...
In the version of ZBOSS included with the nRF Connect SDK 2.2.0 there seem to be headers missing. Looking at the generated documentation (for example https://developer.nordicsemi...
Hello, Could you help choosing the appropriate radio for the following application? I am developing a vessel transponder (with a focus on reducing accidents in the Amazon...
Hi,
I have several Thingy53 devices and I am experimenting with Bluetooth Mesh networks (lights, light switches, etc). I had everything set up and working OK with the...
Im developing a project with OT. Im working over this example . It's configured in NCP mode.
I build the project and flash into the board nrf52840DK but I see tha main...
Hi -- I am having an issue with partition manager when I have mcuboot enabled and an external flash partition selected in devicetree. I've attached a very minimal project...
Hello,
I am writing about an issue that come up with enabling MCUboot.
The device is a temperature/humidity data logger recording data into Storage Partition with NVS...
Hi Madam/ Sir,
I am using your PPK II to measure current consumption. Based on your document, this device use an internal resistor to measuring current. And the PPK features...
Hi, here I have a custom made board that has a MDBT42Q module (nRF52832 based) and has connected a RFM95W LoRA module, using this simple send lora code:
# include < zephyr...
