But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hi
I am trying to modify the MCUboot image to meet the requirements of the project one of the rquirements is to boot the application directly from the secondary partition...
Hi, my region does not support LTE-M or NB-IoT. I would like to prototype an asset tracker with GNSS only. To my understanding, i will be able to retrieve GNSS location data...
Hi, I recently I have implemented the Time Model for the nRF5 SDK for Mesh and happy to share my implementation here: https://github.com/hashing-cell/BLE_Mesh_Time_model ...
Hi
We have a project where 1 central shall be connected to 1-7 peripherals. The central sends a short start/stop message to the peripheral then the peripheral starts to...
I have enabled advertising fast and slow mode. But changing from fast to slow mode is almost at same time. How to configure for changing advertising mode slowly?
The following...
Hello,
I am using the 9160 to send MQTT messages which are received on AWS. I am provisioning the devices by creating a thing on AWS, getting the certificates, and loading...
I have a problem that my nRF52840 Central cannot discover one of the my nRF52840 Peripheral sensor services. With the phone I have no problem. Also other services are detected...
Hi team,
I am using NRF52833 DK with PCA10100 on it and s140 soft device version..
While I am merging the ble_app_uart example with ble_app_multiperipheral example, the...
Hi, I'm currently developing an automatic connection BLE system.
I'm using nRF52840 DK with nRF Connect SDK and S140 SoftDevice.
In fact, there exist already other...
Hi Nordic,
I would like to understand the philosophy behind the nRF9160 DK acting as a debugger. I recover my thinky:91 connecting the 10 pin flat cable from thingy:91...
I was using nrfjprog successfully about a year ago before this evaluation was suspended. When I now try it fails.
```
nrfjprog --log --program build/zephyr/merged.hex...
Hello,
I'm trying to writte a sensordriver for the nuvoton NAU7802 ADC in Zephyr using the drivers/sensor API. Here are the most important (I believe) parts of my code:...
Hello,
I've recently created a custom board based on the NRF52820 which is configured based on the datasheet.
I'm using an NRF52833 DK OB J-Link to program the device...
