But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
I am have programmed my Thingy 91 device with lte_ble_gateway program to collect data from 5 bluetooth devices and send them to the cloud. This program runs fine,...
Hi all,
I've a custom board in which I'm trying to interface SD card with nRF52840 chip.
I've checked connections with multimeter for connectivity and added pins accordingly...
I'm new to the NCS/Zephyr environment. In the past I got the nRF52832 working with the VL53L0x. I ported arduino code of the VL53L0x and got it working well. But now I'm trying...
I have never seen documentation this opaque. How on earth am I supposed to use this documentation to write C code? I can't find any macros, static variables, nothing to get...
Application blinky example hangs when connecting with android app. I get 0x4001 error in app_error_fault_handler().
It is strange that when i use blinky app on android it...
It was my first time working with the Segger embedded IDE
SEGGER Embedded Studio for ARM Release 5.42 Build 2021031901.45616
and NRF52840-DK.
PCA10056
2.0.0
2020...
I have a problem with printk/LOG in one program (samples/sensor/bmi160). All my programs, except this one, gives me serial output from both logging (LOG_INF etc) and printf...
I bought the PCA10056 board. I want to develop my own application over the ble_app_template example. How do I create a ble service? how do i create uuid? I'm confused. could...
Hello,
I tried to setup the UART example provided at this link: https://github.com/Rallare/fw-nrfconnect-nrf/tree/nrf9160_samples/samples/nrf9160
I open two COM ports...
Hello,
I am using nrf connect sdk 1.5.0.
Building example code, error occurs in devicetree.h file.
And when i generate project, i copy sample folder and open in...
I followed the directions in connecting-uart1-to-a-periph-on-nrf9160-dk .
I'm using nRF Connect SDK 1.30 and have compiled the hello_world application for board "nrf9160dk_nrf52840...
Hi, I'm using the nRF9160-DK and I need to implement an external uart communication. Which GPIO can be configured and are available on the various connector?
I have checked...
