This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hi everyone,
Im porting a board from SciLabs to Nordic; since the NRF52811 is in stock I am using it via the nRF52840DK.
The included sample adc application doesn't seem...
Hi,
I'm trying to integrate into my project parts of the SDK responsible for USBD handling, sadly with no avail. Even it I get through all missing files, set all the needed...
Hi, I am using S112, nRF52832 and SDK SDK_17.1.0_ddde560.
Using below code snippet I am putting device to deepsleep. I have turned off the RAM retention. However, still...
I am trying to create Docker image with all the tools to build and flash the board. But I have the problem with nrfjprog:
$ nrfjprog bash: nrfjprog: command not found
...
Hello Nordic Team, We haven chosen a nRF52805 SoC and MDBT42T Module and would like to operate with 2 i2C sensors on two different Pin-pairs. Since the nRF52805 only has one...
Here's what i am struggling with: my code generates a error while building for every line where i use a function starting with "nrf_drv_gpio_..." saying there is an undefined...
Hi all,
I am about to purchase NRF51-DK Nordic Semiconductor ASA | Development Boards, Kits, Programmers | DigiKey but this says for nRF51422, nRF51822 series Transceiver;...
Hello,
I am using the peripheral uart sample and it works fine. My issue is that whenever the buffer is full it automatically sends the data from the com. How do I stop...
I'm working on the nRF5340 using the newest release of the nRF SDK, SoftDevice and zephyr project. I get the connection index from our application but need to retrieve the...
I change nRF52832 firmware to support DFU OTA. But ble_dfu_buttonless_async_svci_init() failed with errCode=0x4.
0> <info> app: Version 1.2.1 0> 0> <info> app: ========...
When I use Keil to build project for supporting DFU OTA. Keil shows changing *.o to *1.o. Is it normal?
Build started: Project: ble_app_band_v4 *** Using Compiler 'V5.06...
