We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
when I call ble_nus_send_string,I got the error, error code is 0x00003003, Then I find error define like below
#define BLE_ERROR_NO_TX_BUFFERS (NRF_ERROR_STK_BASE_NUM+0x003...
I tested BLE mesh example. I have 4 boards 1 nRf52832 and 3 nRF 52840
1 board as client(nRf52832)
1 board as Provisioner(nRF52840)
2 board as server(nRF52840)
i loaded...
Hello
I'm trying to use the secure bootloader from the SDK Examples. It worked all fine with downloading and the example package.
But if I try to make my own application...
I am trying to come up with a BLE solution for a Linux based audio project. The Linux target would function as a hardware appliance and as such would appear as a BLE peripheral...
Hello Community,
I have been trying to avoid asking this question here (it may be trivial) but I guess the answer will help other people as well.
In the ATT_MTU throughput...
I was on Instagram, and I won a green nordic 52 from Nordic. I got it, became frustrated because I didn't have a JTAG debugger, and flashed espruino onto it with nRF toolbox...
Hello,
I have a question regarding the correct way/good practice of programming with the use of SPI. I am using SDK 15.0.0.
I've written some code in a source file peripheral...
hi.........
i am using nrf52832 and segger 15.2
i am merging the two programs in order to send the data through ble to phone(uart app)
i am getting the error
undefined...
hi !
I have start to program the SPI example to communicate with the BMP280 from Bosch and i have seen good results so i'm tried to implement the code over ble_app_uart...
hi..........
i want to put my peripheral device in sleep mode ? how to do that?
i tried this one , its shows error
err_code= sd_power_system_off();
APP_ERROR_CHECK...
Dear Nordic Team,
Thanks for supporting.
Currently i am trying to work with multilink central in NUS_C example based on ble_app_multilink_central. The edited code was...
