We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello,
I wish to create a mesh for my product and I have two options Zigbee and nordic SoC. My application involves very little data transfer and that too at very low rate...
Different examples for s110 use different methods to configure advertising, sd_ble_gap_adv_start() and ble_advertising_init(). What is the guidance for choosing between the...
Hello,
I'm looking to get the nRF24LU1+ dongle to work as a VCP. I had a code running 4 years ago on the dongle as a Mass Storage device but I was wondering if someone...
Hi guys,
I have to port the current library that is working at the arduino uno for arduino zero pro but when I change the board type I get the following errors:
__file__...
Hi
Here's what I would like to do: I have a bluetooth device with an nrf51822, with which I gather some sensor data, with a period of say 1 minute. I would like to store...
Hi,
If the bootloader is allocated 16 kB of flash, can it be upgraded Over-The-Air to a larger size bootloader at a later point, or does that require flashing the device...
I am a beginner and I am trying to generate a data ready event and after that reading the FIFO_Count but FIFO_Count gives me the value 1024 that is the maximum possible size...
Hello,
We are in interaction design in a school in France and we must create a connected object. We bought a BLUETOOTH SMART BEACON KIT (nRF51822) and we would know what...
I used nrf51822_narrow module DT26.
softdevice : s110
application: ble_app_hids_mouse
sdk: nrf51_sdk_v6_1_0
Now , we are able to move the cursor with the mouse of the...
Hi,
In the nRF51-ble-bcast-mesh example, it is mentioned that "handle_count" refers to "The maximum number of handle-value pairs available to the application. May not be...
With reference to the IoT SDK for nrf51, I see the APIs and examples of either server or client.
In order to create mesh or peer-to-peer, which API should I use? Or do...
In the description of nRF51-ble-bcast-mesh, there is mentioned that there could be up to 155 mesh values:
There may be up to 155 "Mesh value" characteristics in the mesh...
Hi,
I'm wondering why I can't see any packet from example led_mesh in your's sniffer?
Theoretically it's only Nonconnectable Advertisements or I miss some information...
