But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
I am trying to send data from icm20948 sensor from the sensor node to the observer node using ble mesh. Due to the data from icm20948 is too large (9 uint16_t, 18bytes) for...
Hi Nordic community, I have received nRF7002DK device and trying to make it work on v2.9.0 sdk. I'm working wifi sample project,successfully building and flashing in the device...
I have installed the nRF Connect SDK, with both the toolchain and SDK set to version V2.9. I selected the nrf54l15dk board for development, but I do not have a physical nrf54l15dk...
Hello ,
I have taken reference project which use all leads and buttons of Evaluation module NRF52833.
I want to create overlay file for this project and remove few led...
Hi Nordic Team,
The OpenThread API function otCryptoAesCcm() is not working after updating to NCS v2.6.0.
Setting CONFIG_OPENTHREAD_NRF_SECURITY_CHOICE =y seems to...
Hi!
I'm using some common bootloader code for different devices. One of my devices is a bit different, with an LED library that caused me to increase the BL size in the...
hello Nordic
i am using ncs 2.8.0 with nrf52832 and mrf52840
i am decoding a cbor file with the 'zcbor_map_decode_bulk'
the 'my_implementation_decode' is just a function...
Hi,
I'm polishing up the development of my product, and I need to use the LPCOMP driver to wakeup my NRF52840 from the deepest sleep mode. There is not much information...
Hello,
I have implemented an application for the nRF52832 that uses peripheral NUS with LittleFS. The application receives sensor data via UART and stores it to a file using...
I have devices that manually define PDP context 0 in order to set the APN to the required value for the SIM.
Typically, once connected to the network, the IP address gets...
nRF5_SDK_17.1.0
PCA10059
According to the source code:
The data length is fixed,it will still copy element-size bytes to buffer even if no so much data.
For communication...
Hi! I have multiple peripherals and centrals that I want to manage connections to. From the peripherals perspective, Is there a way to filter which centrals can connect to...
Hello,
In an nRF52840, NCS2.7.0 application (based on BT NUS shell) I need to address the following case:
UART Interrupt handler monitors incoming bytes
A working...
Hi,
I am using the Thingy:91X device and can see the updates appearing on the hello.nrfcloud.com web application, but I would like to have access to the 'device' via the...
