Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi Nordic,
I want to send JumpToBootloader() command to nrf52832 module to make it enter dfu mode and update.
But I got the following error, can you tell me what is the...
Hi, I have been doing my development on the 9160DK and now its time to move the code over to the thingy 91. I managed to get the 9160 flashed by following ( https://devzone...
I modified the ble_app_gls example using the whitelist paring mode. The code is from ble_app_hids_keyboard.
1. The code goes fine when using whitelist paring mode.
2....
Hi I am using the ble nus with throughput from this github project. I can send like half of the total packets before encountering the not able to allocate uart send data buffer...
Hardware: nrf52840 DK.
Software: ncs version v1.7.0 and default SEGGER IDE for Nordic.
When I first build the machine learning application in nrf, there is no any problems...
Hi DevZone !
I am using the nRF52840 for development and after some tests one of the chips could not access its memory flash in the function fds_init() in the library fds...
What is the difference between NRF5340DK and NRF5340PDK? If so, is there any way to make nrF5340PDK into NRF5340DK board? Why I use NCS version 1.7.0, to compile nrF5340DK...
Hi,
I'm trying to implement eddystone in my application, using the example.
The problem is the I can't build my project, as I have an error regarding DRV_RTC_RTC1_INST_IDX...
Hello,
With me is two SES projects that are in need of both the softdevice and an application.
One of these projects involves combination of an application and a softdevice...
Currently am working on a project that has strict size constraints. My interest is to have the SoftDevice run without the MBR if that can be made possible. The project is...
I have been reading the nRF52840 product specification guide and find the PPI an interesting feature potential to use in my application. I'm would like if possible to connect...
Hi Nordic,
I don’t know if the question I asked is stupid, but it does bother me for a long time.
Q1 - Can I use uart(serial) interface to update Firmware (including...
Hello everyone! I am developing a prototype custom board with an nrf52840 dongle and some sensors. The first sensor is a bme280 over I2C and there is an example in the sdk...
