Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
I can only find the 1.3.0 nRF52 DK Hardware User Guide version / revision on your site.
I need the nRF52 DK Hardware User Guide version / revision 1.2.4 for my SDK - it...
Hi, I am looking into printing the RSSI values for both the boards in a walkie-talkie configuration example for the LE Audio dk. I tried reading other discussion about printing...
I have a project using nRF Connect SDK v1.9.1 and recently started having the issue that when I build it in VS Code with the plugin it always asks me to do a Pristine Build...
Looking for suggestions for power management on a product
We have a wearable that needs to periodically sync data to the cloud through a gateway. Currently the wearable...
I am working on creating a Bluetooth Mesh network using the BGM220P as a sensor node. My goal is to send sensor data (e.g., temperature) from the BGM220P and have it received...
Hi
I am having some issues flashing the modem firmware to a custom board using the nrf9151 SiP.
I can, with no issues, flash programs to the chip, but when i want to...
Hi.
I'm playing with an scenario based on two nrf52840dk and a dongle.
I have deployed a OTBR on a Linux Ubuntu22.04 and flashed the dk with OT COAP Server and Client...
After a lot of help, I've managed to get a central_uart with custom UUIDs going. After stripping out as much unwanted code and callback functions as possible, moving UART...
Hi,
I am new in Device tree concept. I am trying to operate a buzzer via PWM.
In our board, the buzzer is connected in GPIO 3.
I changed a segment in file nrf52dk_nrf52832...
Hello,
At the moment I have a correctly working Azure IOT hub connection.
DPS works, device twin configurations works and transmitting data to the hub is also no problem...
Hi All I started on the fundamental course in the academy. I did everything by the letter in lesson 1 / exercise 1 Yet when I plugged in my 52840 devkit I could no load the...
Hello,
I am working on a project involving the nRF54L15dk and need to connect a peripheral's reset pin to the reset functionality of the DK. However, I noticed that the...
This is heavily processed code just to show what I'm doing with discovery: I can see that first time I call for discovery I get BT_GATT_DISCOVER_PRIMARY cnt_3 = 3. Then I...
I discovered this chipset and have found a dev board on eBay for $37. Is it worth it to tinker with? I have the 2.8 version of the toolchain. And Sdk. On vs code.
I have...
