After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Dear Tech,
I am using the pre release version of the VS Code plugin and NCS v2.7.0 for development. Our team hopes to develop the product based the official version to ensure...
Hello Everyone,
I used the HRS application example for LESC secure communication and added the OTA to the HRS application. After adding that, the device restarts. I debugged...
I am programming now nrf52810 I try to merge uart functionality to ble_app_blinky project but it does not work i debug and found out uar_error_handler() never been reached...
Hi.
I am using a custom board on the nRF52820 microcontroller (wiring diagram in the figure). When the microcontroller is powered only from the battery (via external LDO...
Document: HTTPS_SAMPLE_2024_09_19T02_55_15_089Z.txt I was programming the HTTPS sample with default parameters. I managed to connect to "example.com successfully". I managed...
I'm working on a BLE project based off of the peripheral_lbs sample within the nRF Connect SDK v2.7.0. I am attempting to increase the BLE security level up to either level...
Hi,
I am working on a battery powered device that collects data, save it to files and go to sleep, when it is not connected to a laptop via USB. When connected, the device...
Hi,
I want to change the LED pin that blinks to indicate BLE advertisement to pin 6. I have changed the LED_1 and LED_STOP in pca10040.h to 6:
I have also set NRF_LOG_BACKEND_UART_ENABLED...
Hi.
I am developing a custom board using nRF52840 inside a Moko MK08A and an accelerometer LIS2DH.
My circuit has a 3V3 voltage regulator just for the LIS. The microcontroller...
Hello
I'm trying to connect muy Power Profiler Kit II to my PC, and when I choose the device from the list it pops-up:
I clicked 'Program' and after I supposed it...
Hello,
I'm trying to access active PCO from nrf9160 applicaton to be able to diagnose problems like missing DNS, wrong access point etc. I tried using %XPCO command, AT...
Hello.
I am developing device using nRF52840 and i have question about analog pin usage.
My circuit is analog Pins getting voltage supply while nRF52840 is not used...
Hello Nordic team,
how is it possible to perform Packet Error Rate testing during an active OpenThread connection between two nRF52840 devices? The requested test scenario...
