Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
hi support team，
how to select network manually, using “8.1 PLMN selection +COPS” or "8.16 Mobile network operator %XOPCONF", which command should customer use, and what...
I am trying to implement mesh with NRF SDK V17.
But nrf5_SDK_for_Mesh_v5.0.0.
When I build the light_switch application, I get the error "boards.h No such file or directory...
Product info:
NRF52840
nRF5_SDK_17.1.0_ddde560
s140_nrf52_7.3.0_softdevice
I am working on a product with a NRF52840 and SDK 17.1.0 and a cell modem. This product...
I'm having no luck in getting JLinkExe or nrfjprog to see my BMD-350 device on my custom PCB.
I have read though all the threads here that reference similar issues and...
Hi
Because the nRF52 SDK doesn't support scheduler server modeI and scheduler setup server model, but I need this model, and I don't know how to implement by myself, could...
As referenced in a previous ticket: devzone.nordicsemi.com/.../nrf9160-mqtt-simple-example-configured-to-talk-to-test-mosquitto-org-using-mutual-tls-on-port-8884 We are seeing...
Using nRF Connect SDK v2.0.0 on Windows in VS Code. Hardware is a U-Blox BMD340 demo kit with nRF52840.
We've built and run the following OpenThread sample applications...
Hello,
I am trying to use http requests on Thingy91 and therefore I tried with the sample from zephyr/samples/net/sockets/http_client.
I can build the project without...
I have a conexio stratus board that I would like to debug the modem with the LTE Link monitor. I am not using the Zephyr frame work, but I can flash pre-compiled hex files...
There's a few threads out there with similar questions, but I haven't seen a direct answer to this.
If I build with nrf5340dk_nrf5340_cpuapp, can I use the entire application...
Hi,all~
The program runs on nRF52833. At the beginning, MCU sends data to nRF52833 through serial port, and the data can be received correctly(pic one）. When I use THE...
I currently have an issue where by the Chip-Select is not toggled at all when configuring the csn pin to pin <18> on the Nrf52840 using Zephyr (version 2.7.1).
See dts configuration...
