Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hi,
I am trying to make it so a client can publish to groups without using the provisioner to set the publication address. I presume some callback is being used, but I do...
Hi Team
I try to change the TX power in NCS with soft device control. I follow the example code of \samples\bluetooth\hci_pwr_ctrl. And I add the some test code in function...
I am going to use the BLE beacon function for simple home networking.
The device should be able to switch between beacon transmission mode and beacon reception mode (beacon...
I'm trying to get our mouse to connect to the dongle and it's not working, so I'm troubleshooting.
I noticed that I get 3 of these <err> bt_hci_core: Failed to add IRK to...
I am running into an issue around flash management when attempting mesh coexistance with BLE.
The call I am failing on is during mesh_init().
Line 298 of flash_manager...
Hello,
I'm making an application that I want to have the following behavior:
1) 52832 starts in sleep mode
2)P0.14 pulls to LOW which brings out of sleep mode and...
Hi
I'd like to use NB-IoT in Switzerland.
According to https://www.gsma.com/iot/mobile-iot-commercial-launches/ there is support for both LTE-M and NB-IoT in Switzerland...
Hello, I am working on the NRF9160DK and I have an issue with the asset tracker sample. Firstly, I followed the guidelines explained in the video "Unbox and get your Nordic...
hi support team,
i have ESB project for customer, and now i have one fundamental question about RTC cc compare event, i am struggled in this problem.
static __INLINE...
Hi,
I'm working on direction finding with nrf52833dk (my own board latter on) and Nordic antenna matrix. I'm using NCS v1.6.0-rc2 and example Direction fing connectionless...
Hello there,
I'm facing inconsistency across two nrf51 PCB boards in term of sending the device name. I'm running the same exact code on both. One is advertising the device...
As shown in the provided picture, the download worked after connecting, but the function does not work.
I have checked the following. 1. Check the operation status of...
Hi,
there are couple of examples on NCS with edge impulse. I would like to know how much space edge impulse add to the application, and to see if it can fit into nRF52840...
