Dear friend I checked the data sheet of 52820 and I didn't see any LPCOMP peripherals. Check the data sheet of 52832, there are LPCOMP peripherals. Comparing COMP and LPCOMP...
Hi,
I am working on internal flash nRF52832 merged with twi sensor, my sensor function will return a string . How to assign the string to the my_data.p_data . i am getting...
Developing on the nrf51822
Have working code for the nRF52840 Dongle using the pc-ble-driver therefore all Bluetooth work is done using sd_* calls. The PC provides easy...
Hi ,
I would like to know if a matching network is needed if I am only using a single external flex antenna for both LTE and GPS using a RF switch between them and a uFL...
I am a student interested in Nordic.
My coding skills are very poor.
So I want to get help.
I want to use the vl53l1x sensor in nrf52. (My ultimate goal is to measure...
Hi,
As seen in datasheet nRF52840 has one antenna Pin. We can connect either PCB Antenna or Ceramic or External Antenna. Is there a way I can use any RF switch to toggle...
Hi, I have been experimenting with an NRF5340dk for the past few days around the application of emulating a Mass USB storage device when connected to a PC.
I came across...
The error^^
Following the steps outline in this article to add MCUboot: https://devzone.nordicsemi.com/guides/nrf-connect-sdk-guides/b/software/posts/ncs-dfu
start with...
Hi,
I am building an app which has 7 central links and 1 peripheral link with PCA10040 DK board and S132. The central links look OK. But when I use the peripheral connection...
Hi There,
Environment Description:
1. nRF Connect for VS Code v2023.1.44.
1. NCS Version v2.0.0.
2. Zephyr v3.0.99-ncs1.
3. MCUBoot v 1.9.99
4. NRF52840.
5....
I'm working on a project that I need to write a file in the flash memory, but when I calling the function to open file (fs_open), the microcontroller crashes completely and...
Hello! Apologies if my ticket subject is a little unclear or if the terminology isn't correct. I'm currently trying to investigate an issue that causes my device to get stuck...
Hi, devzone,
I'm currently trying to flash the nrf52840 dongle from a custom IMX6-Ull board where it is attached and I'm also able to communicate and run the application...
Hi!
I am currently working on a project that involves taking a command sent over UART and broadcasting the data sent in that command to a number of BLE Mesh devices. I currently...
Hi,
I can't implement advertising on CODED PHY with primary advertising use PHY 1M and secondary advertising use CODED PHY on NCS2.1.1. Then I read the description about...
I am looking as using pwm and timers and trying to get them to use the HFXO rather then the internal RC as I need the higher accuracy. I know how to start it using the below...
Hi,
we found out after upgrading to SDK2.2.0 that sdc_hci_cmd_vs_zephyr_write_bd_addr does not accept a public bluetooth address anymore, this worked fine with SDK 2.1.0...