Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
As part of a university project I am trying to read an analog signal and transmit it at the maximum data rate over ESB. But I cant seem to get above 1700kbps without any of...
Hi Nordic team,
We are designing a custom board using an nRF54L15 together with an nRF7002 WLCSP.
Our board has a single 3.3 V power rail. We would like to confirm the...
Hi all,
Can anyone guide me to the right path where I can get how to interface an E INK DISPLAY(ET014TT1) to the NRF52840 DK board or tobwhere I can get the necessary steps...
I'm having strange behaviour after switching to 3.4.0 on nrf9151. Our existing application was working well on 3.2.0 but showed no life with 3.4.0.
To demonstrate, I built...
Hello,
I am having trouble programming the nrf5340 chip using SWD.
Set up:
Custom hardware with the MDBT53V-1M module from Raytac, nrf5340 chip.
SWD, using J-Link...
The nRF7002 Evaluation Kit and the PCA10143 Development Kit both show multiple vias to the ground tab pin 49 but there is no direct connection from the tab to pins 27, 28...
I want to use P2.00,p2.02,P2.04, P2.0 for UARTE20 on NRF5415DK.
This is to use the uart as an interface for HCI uart with NRF54 as the BLE controlller.
How to enable the...
I am setting up our production facility in India. Brought out our test jig software that flashes the nRF53 modules.
I use nrfutil to program the boards via "nrfutil device...
I am using the Thingy91X kit, and I am trying to make a sample 'hello_main" to work on the nrf5340. My project configuration is as follows:
Sample: zephyr/samples/hello_world...
Dear Experts,
We are bringing up a custom nRF54LS05B module and have built a small production-test firmware on top of the `radio_test` sample. While characterising current...
ncs\v3.4.0\nrf\scripts\generate_psa_key_attributes.py doesn't seem to support X25519 PsaKeyType and allowing it to be used with ECDH algorithm. Is this just functionality...
