Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
Hello,
Fllow the guide of Configuring and performing DFU over Mesh,I can update firmwre successful use DFU:
Source: Example/Dfu
Target: Blinky(about 180 segment)
But...
Hi, I am working on custom board with nrf9160. I want to use LTE LINK MONITOR but my uart don't work. I create simple helloworld application from samples. I change uart0 rx...
I'm trying to add a second element to (light_switch\server) (SDK_for_Mesh_v5.0.0). I've already have a look at this post , it gives an idea but I found that it's not applicable...
Hi,
Again the topic which has already been discussed several times in this forum. I just want to share my experience and perhaps help other users having difficulties.
...
EDIT: We found the reason for this and it is a hardware issue. This question can be deleted as it is no longer valid.
-----
Hello,
We are currently developing a...
Hi,
I am working on a project where my mobile phone will be acting as a central device and nRF52840 DK will be acting as a peripheral device. I used the nRF UART and nRF...
I'm advertising a custom 128bit UUID for my service.
when I added the buttonless DFU service, the UUID in the advertisement packet got mixed, I ended up with the base uuid...
Dear nordic,
I have some doubts regarding ble nus service.
1. how many bytes i can transfer in one packet t a time from smart phone to nrf52832 viceversa?
2. Is it any...
We are using the Nordic nRF52832 and the nRF51822 in two different products. We seek to distinguish between these products and other BTLE devices with a scan using a dongle...
Dear Sir,
I am using nrf52832
SDK 15 and softdevice s132.
I have made a custom board using BMD300 module (nrf52832 based module).
I have takem the following pins...
Hi Everyone,
I am having this issue where i am not able to get ADC and BLE working together.
I am using external ADC and i am using BLE app uart as the base to develop...
I have a basic question regarding the interrupt priority. I want to know if the lower priority is triggered while the higher priority interrupt is served, is the lower priority...
Hi
I want to use GCC 4.9 2015q3 to build code on SDK v15.2 and v15.3 but it shows it cannot find 6 2017-q2-update and 7 2018-q2-update.
Checked Infocenter - Secure DFU...
Hello everyone,
I am trying to measure the current being consumed by nrf52840 using an external power supply.
Setup: I have connected 3.3V DC power supply to connector...
Dear Sir,
I am using nrf52832.
SDK 15
soft device s132.
I need to add the battery level also to the advertising packet.
Currently I have done code to read the...
Having problems getting SPI master to work with CC3100 wifi chip.
Using TI SPI porting diagnostics to verify operation.
Based on recommendations, attempted to switch to...
I've got a use case that can essentially be boiled down to two battery-powered devices that have a button and an LED; when the user presses a button on device 1, the LEDs...
When using nRF Connect I by mistake hit erase-all, which erased the bootloader (and cleared UICR?)
I flashed the MeshSDK v3.0 bin/bootloader/gccarmemb/mesh_bootloader_gccarmemb_nrf52840_xxAA...
I am getting closer to utilizing the Zephyr "toolchain?" within windows 10 environment. It has not been an easy setup and hardly a single exact recipe to set it up exists...
