I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
Hi Nordic,
I want to send JumpToBootloader() command to nrf52832 module to make it enter dfu mode and update.
But I got the following error, can you tell me what is the...
Hi, I have been doing my development on the 9160DK and now its time to move the code over to the thingy 91. I managed to get the 9160 flashed by following ( https://devzone...
I modified the ble_app_gls example using the whitelist paring mode. The code is from ble_app_hids_keyboard.
1. The code goes fine when using whitelist paring mode.
2....
Hi I am using the ble nus with throughput from this github project. I can send like half of the total packets before encountering the not able to allocate uart send data buffer...
Hardware: nrf52840 DK.
Software: ncs version v1.7.0 and default SEGGER IDE for Nordic.
When I first build the machine learning application in nrf, there is no any problems...
Hi DevZone !
I am using the nRF52840 for development and after some tests one of the chips could not access its memory flash in the function fds_init() in the library fds...
What is the difference between NRF5340DK and NRF5340PDK? If so, is there any way to make nrF5340PDK into NRF5340DK board? Why I use NCS version 1.7.0, to compile nrF5340DK...
Hi,
I'm trying to implement eddystone in my application, using the example.
The problem is the I can't build my project, as I have an error regarding DRV_RTC_RTC1_INST_IDX...
Hello,
With me is two SES projects that are in need of both the softdevice and an application.
One of these projects involves combination of an application and a softdevice...
Currently am working on a project that has strict size constraints. My interest is to have the SoftDevice run without the MBR if that can be made possible. The project is...
I have been reading the nRF52840 product specification guide and find the PPI an interesting feature potential to use in my application. I'm would like if possible to connect...
Hi Nordic,
I don’t know if the question I asked is stupid, but it does bother me for a long time.
Q1 - Can I use uart(serial) interface to update Firmware (including...
Hello everyone! I am developing a prototype custom board with an nrf52840 dongle and some sensors. The first sensor is a bme280 over I2C and there is an example in the sdk...
