Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi Nordic,
we started with the light_switch example
and created a second onoff model to it -> system compiles but runs into error
also tried adding a other generic model...
Hi All.
In custom report descriptor I try to use this code:
ret_code is NRF_SUCCESS
but on host while reading feature report I don't se a changed value. Maybe I'm...
Hi,
If an ESB PRX has queued a 250-byte auto-ack payload, that will take around 2ms at 1Mbs to transmit.
If the ESB PTX has the standard 250us repeat interval, will the...
I am confused about the value of RX_PW_Px register what will be the value of this register if more than 1 dynamic payload packet arrives on the same pipe-x.
I'm a beginner I'm having hard time understanding UART. In my opinion, the documentation is going too straight to the technical details and tutorials without even starting...
Dear friends,
Is there any ideas for measuring the distance between a BLE module and a beacon module without using RSSI?
With Regards,
Sunil
Calixto Systems
hi..........
i have developed nRF52832 QFAA using your schematics,and i have added sensor to it . Now i can able to flash the code and ran successful but i can't able to...
Hi,
We are developping a system connected to several devices based on NR52 MCU.
The DFU works with the nRF connect application.
Now, we would like to update the device...
Hi,
I am just getting started with the thingy 52 and I need some guidance. I am a EE by profession so I feel a bit out of my league here.
When I unwrapped my thingy I...
Hi there,
I am adding security to my service characteristic and i found that for security mode 1 level 4, bonding is required in order to access characteristic values. Is...
Hello,
My problem is pretty much identical to this one:
devzone.nordicsemi.com/.../
My functions look exactly like the ones posted in the original question and I...
Hello, and thanks for all the great examples!
I've gotten the COAP transport for background DFU working on my custom hardware platform and app, however I have noticed that...
Hi,
I do have a NRF51-DK and want to use it as a external programmer. I connected it to the OUTPUT Port which worked fine, then I flashed the mbed firmware on it because...
Hello,.
I have a question about using app_usbd_cdc_acm_read and app_usbd_cdc_acm_read_any in SDK15.2.0,
I am not sure I fully understand the description in reference...
