I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
I would like to run a SPI program that reads data from a non Nordic chip. I would like to then take the data I received over SPI and send it via BLE.
Are there any code...
I'm trying to place my device in a low power mode for shipping. I used Logging and CLI while its in operation, but I'd like a way to enable/disable the CLI+Logging over BLE...
I'm testing a simple program below, which writes three params followed by read the three params.
Each params is set in tx_buf correctly, but nvs_write does not seem to work...
I am developing a hand-arm vibration sensor for read-out via BLE
Development platform NRF51822 and S110
I'd like advice on how to configure the softdevice and the two...
Nrf52832 sdk15.2 is debugged online after burning softdevice, bootloader and bootloader settings. In the ble_dfu_buttonless_async_svci_init() function, the error NRF_ERROR_SVC_HANDLER_MISSING...
HI,
The nordic MCU I am using is NRF52832.
I am flashing the example code ble_app_uart which is coming in the directory "nRF5_SDK_15.0.0_a53641a\examples\ble_peripheral...
Using Telia APN the following is added after bsd_init()
AT+CGDCONT=0,"IP","lpwa.telia.iot"
However, this AT command sent on the AT socket fails with "ERROR". Does the...
I have 2 client nodes and 1 server node . How can i possibly recieve packets more than i send. I sent 114 packets from 1 node and 104 from another . I am receiving 302 packets...
We are developing Beacon using NRF51822 SoC.
Basically We want to classify our beacons from other manufacturers and want to give our each beacon an unique ID. Please provide...
Hello,
I am new to nrf52832 ,
My question is how to start the timer when external interrupt was rise and turn off timer again when external interrupt was rise
Kindly...
Hello to everyone.
I'm working with Light_switch example in Mesh 3.1, with nRF52832 SDK (PCA10040). I'm trying to stablish communication from server to client, sending a...
Hi everyone,
I'm trying to understand how BLE connection interval works and why my long read is so slow. My slave is nrf51822 with Softdevice 130 v2 and nRF5 SDK v11,...
