Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
I want to place a IoT application on an Application chip and connect it to a Connectivity chip running the BLE IoT SoftDevice.
Does the nRF5 IoT SDK support serialization...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
I am coding a Sharp memory LCD display using SPI and the nRF51422 development board.
I have tested the SPI connection using a logic analyzer and signals are being...
I will start doing a custom PCB (1.3cm diameter) with a nordic BLE, any recommendations about the components needed and design?. I need to use mbed programing tools, any experience...
Hi,
After training on a PCA10028, i want to develop on my personal board.
I use keil but i saw a problem.
The libraries are all in folders of folders in the sdk folder...
I don't know why I didn't notice this blurb in the reference manual sooner. In pretty much all peripheral sections (such as SPI), you have this warning:
Therefore, the...
When loading the ble_app_uart_s130_pca10028.hex file (Windows 10)
from nRF5_SDK_11.0.0_89a8197/examples/ble_peripheral/ble_app_uart/hex using nRFgo Studio - Program Application...
Hi,
I programmed the NRF51-dk to take ADC samples and transmit those values at 8 bit resolution. Now I want to send a 10 bit resolution value over BLE UART, but I believe...
Hi everyone,
In my low power application , I use PORT EVENT to detect the interrupts of my two pins.
when I use only one pin interrupt, it's working well .
But with two...
Dear All,
We are implementing 8 Pheripheral Nodes and one central node with S110 and S120 respectively.
We have our custom board with us we are able to connect the pheripheral...
Hi
I want to run RAM retention sample example with sd_app_evt_wait(void) .is it possible?
is it require soft device to load first?
I have included S110 soft device of...
