the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Dear Sirs!
I am going to use nrf_drv_spi_xfer to read 15 bytes periodically (Approximately each 4 ms) according to GPIO (GPIOTE Event via PPI). To do it I am going to call...
I'm attempting to use a vendor or custom model to deliver sensor data through a ble mesh using a nrf52840dk board. On Ubuntu, I'm using the nrf connect sdk v2.2.0. i have...
Hi,
We are using the nordic sdk 1.9.1.
I have created my own project and i want whole sdk commit to my repo. I am able to build the project. I am not able to commit the...
Hello Guys,
I am trying to implement our own firmware update over ble in Mobile App.
The whole process is succesfully done by Nordic Application (Device Manager).
I...
Hi,
I'm implementing a circuit that uses both ble and usb communication using nRF52840.
I'm configuring power source and i'll configure schematic like reference circuit...
Hi there.
I am currently developing a simple asset tracker based on several examples using nrf9160 custom board.
So I am using several examples like mqtt_simple, gnss...
Hi,
I am using STLED524 intelligent matrix LED display driver IC for my project.I need to interface STLED524 with nRF 52 board.I am checking for driver library for it.But...
Dear All,
I'm implementing a SNTP sync over Ethernet and found the following issues:
1- CONFIG_DATE_TIME_AUTO_UPDATE must be disabled to get a NTP time sync scheduling...
It seems like there are lots of questions regarding simple GPIOs and devicetree, but I can't quite find something that describes my problem:
I am using the nrf52840dk...
Hi,
Our team is developing an application based on the nRF5340-DK - we are developing on the DK while our hardware is in transit. Our schematic largely follows the reference...
I have developed a thread network using nRF52840 dongle and Raspberry Pi 4B. I have checked from the command line of the RPi, the transmit power is 0dBm. Can you please confirm...
Hi,
I use embedded wizard tool to handle display graphic and I need allocate a RAM buffer for it. I need to write frame buffer ram start and size in embedded wizard config...
Hi all,
I want to compile chip-tool so that I can make 5340 into a matter network. But I always fail to compile.
environment:
raspberry pi 4B + ubuntu-22.04.1-preinstalled...
Hello,
I am trying to load an application update from a server into external flash, the download itself is working but mcuboot is not:
I need to use the external flash...
