Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
nRF52840, nRF Connect
I was looking at the button example and it is apparently a little different then in the nRF5 SDK kit. In the SDK you had a callback and inside that...
Hi!
For a custom project, I need to enable and disable soft device on a peripheral. I'm able to enable/disable softdevice for two cycles, then I get this error:
<error...
Hi,
I'm trying to mount two spi flash device on spi0, but can't found the second one(device_get_binding() return NULL).
The two device has compatible ("jedec,spi-nor"...
Hello Support,
In my project I use the nrf52840 with the nRF Connect SDK to create a OpenThread device with an Secure MQTT connection to a broker.
I've got the OpenThread...
Hi. I am trying to output a square wave on to separate output pins. I want to have one inverted, however I can't even get the same output on both pins at the moment. The pin...
I want to use HCI_USB on nRF52840 board(nrf connect SDK).
Legacy Advertising Scan is success.
But,, I don't know how to recieve the Extended Advertising Scan.
Please...
We have an nRF52840 operating as BLE peripheral that ix using sd_ble_gatts_hvx() to notify an attribute value. Because we are using an RTOS, after calling sd_ble_gatts_hvx...
Good morning,
DK: nrf5340 Audio DK
SDK : V2.0.0
Toolchain Manager: V1.1.3
nRF Connect for Desktop: v3.11.1
I am trying to work with nrf5340 Audio DK. I was able...
Hi,
I was working with my Thingy:91 all worked fine. Wanted to upgrade to latest firmware and somehow in this process the USB interface stopped working. I switched to use...
hi,
i am using sdk_17.0.2 and nrf52840.
I want to get 6 pwm outputs like in the picture.
They all have to start at the same time.
20 khz signals should be.
i...
