Hi,
I'm migrating from SoftDevice 6.0 to SoftDevice 7.0 and I'm trying to implement the DFU in SDK6.0. I am experiencing an issue where whenever the DFU begins(reaches 0...
I have already made code of 3 pwm channels using c[0],cc[1],cc[2],cc[3]. I want 4 PWM channels but I dont have more cc registers left so how can i code it. plz help me.
ALso...
Hello, I have purchased this kit on ebay. www.ebay.com/.../301182420397
Can somebody point me to where I can get documentation on this kit, it came in with mostly Chinese...
According to the nRF51 series reference manual.
10.1.2 Debug interface mode
Debug interface mode is initiated by clocking one clock cycle on SWDCLK with SWDIO=1. Due...
Hi,
I was looking at the .map for my project and I noticed that pstorage.c was taking up a bunch of RAM (~600 bytes), which I thought was a lot, so I went into pstrorage_platform...
The document nRF51422_Evaluation_Kit_User_Guide_v2.0.pdf says:
Locate the Heart Rate demo project found in the folder
ARM\Device\Nordic\nrf51422\Board\pca10003\s310\ble_app_hrs...
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
SDK 16
nRF52840 with s140
Hello,
I'm working on implementing an assert handler and would like to store the file/line hash in NVM. I currently have fstorage configured...
HI..i am trying to implement multilink central with nus service..but it is getting error at lbs_c_init();.what is the reason..can anyone help..i also changed the central link...
Whenever I try to debug my code, it gets stuck at fault_s_S as shown below
I experienced that one of the possible solutions to avoid this is to browse fw_info.h when the...
Hello,
Is there a DOC available for the nRF52832 module, specifically relating to the RED directive? I was able to find one for the nRF52 dev kit, but not for the module...
Hi there!
As a new developer for the nRF5 SDK, the choices are bewildering and I could not find documentation that gives a clear direction. If there is, please share the...
Using SDK13 with nrf52832 , I was looking for hours how to set up a simple PWM signal.
I don't want to use the example, it's a huge mess, it's not clear and you can...
To build my own application or to programm the nRF9160 DK i have to work with SEGGER Embedded Studio, which i have already installed.
In the next step i have to do the following...
Hello,
I'd like to understand a bit more about transmit buffers for sd_ble_gatts_hvx() calls. Our peripheral application is developed using SDK 15.3.0 and S112 for nRF52832...
Hi,
reading through the gnss socket configuration parameters it came a question to my mind regarding the Power Save Modes.
Is the PSM configuration applied when the GPS...
Followed the example https://github.com/Rallare/fw-nrfconnect-nrf/tree/nrf9160_samples/samples/nrf9160/spi
but getting spi received value 0xff each time
my conf file:...
Hello, I am a bit confused with the ARM Cryptocell 310 engine. As I can see this software is proprietary but in nrf5 sdk there is the cryptocell engine as external library...
Hi,
I am using nrf52810 ,softdevice 132.
I am trying to implement whitelist in ble_app_uart code (peripheral side).I take reference from HID mouse example.
Code compiled...
