I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hi, I am using S112, nRF52832 and SDK SDK_17.1.0_ddde560.
Using below code snippet I am putting device to deepsleep. I have turned off the RAM retention. However, still...
I am trying to create Docker image with all the tools to build and flash the board. But I have the problem with nrfjprog:
$ nrfjprog bash: nrfjprog: command not found
...
Hello Nordic Team, We haven chosen a nRF52805 SoC and MDBT42T Module and would like to operate with 2 i2C sensors on two different Pin-pairs. Since the nRF52805 only has one...
Here's what i am struggling with: my code generates a error while building for every line where i use a function starting with "nrf_drv_gpio_..." saying there is an undefined...
Hi all,
I am about to purchase NRF51-DK Nordic Semiconductor ASA | Development Boards, Kits, Programmers | DigiKey but this says for nRF51422, nRF51822 series Transceiver;...
Hello,
I am using the peripheral uart sample and it works fine. My issue is that whenever the buffer is full it automatically sends the data from the com. How do I stop...
I'm working on the nRF5340 using the newest release of the nRF SDK, SoftDevice and zephyr project. I get the connection index from our application but need to retrieve the...
I change nRF52832 firmware to support DFU OTA. But ble_dfu_buttonless_async_svci_init() failed with errCode=0x4.
0> <info> app: Version 1.2.1 0> 0> <info> app: ========...
When I use Keil to build project for supporting DFU OTA. Keil shows changing *.o to *1.o. Is it normal?
Build started: Project: ble_app_band_v4 *** Using Compiler 'V5.06...
We are using the Softdevice controller from the nRF Connect SDK on the nrf5340 processor and have implemented the commands to read and set the tx power level in the controller...
