Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
Hi,
I’m running the SDK 17, S132 and I do have the PC10040 board.
My embedded bluetooth application will work as a BLE UART, I will send and receive small blocks of data...
Now I use nrf52810 to develop a device, and now I want to use SD_ power_ system_ Off (); turn off the device, and now turn on the device again. What can I do to achieve this...
In the instructions for setting up a project in Segger Embedded Studio it states...
Select File > Open nRF Connect SDK Project .
To import a project into SES, you must...
Hello,
I encountered a problem. When I turn off app_timer during timeslot interruption, it cannot generate app_timer interrupt code show as below:
I am using app_timer2...
I have an application which is currently using a the custom RADIO_MODE_MODE_Nrf_250Kbit mode, and I want to port it to the 52840 and 52911 using
RADIO_MODE_MODE_Ble_LR125Kbit...
To the kind attention of Nordic support team,
I'm very interested in understanding how to have firmware that is working as in PCA10059 in respect to USB bootloader and fw...
hi everyone
I'm new for mesh. having read the document,but have some question.
1 Could the mesh DFU bootloader update the source devices' application through its serial...
Dear all and Nordic Staff:
Thanks for your support as usual.
I have a new application project with BLE and Zigbee dual stack protocol for industry market.
May you suggest...
One of the nRF52840-DK (PCA10056 v2.0.0) we are using as a programmer and debugger for our custom board has started repeatedly resetting the custom board whenever an RTT console...
ble_gatt_db.h and ble_db_discovery.h each contain #defines that are problematic, BLE_GATT_DB_MAX_CHARS and BLE_DB_DISCOVERY_MAX_SRV respectively.
Of course, one can change...
We use NRF52832 in the remote control of the car。 We measured the average current of power consumption at about 1uA.Every 300ms, the current curve bounces to the transient...
I would like to use the RTC in the nRF52833 as a clock-calendar. The device will normally be powered by the USB Vbus but must have power fail protection to insure the integrity...
