I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hi,
I have following problem:
I try to synchronize specific event let's say every three seconds. My simple test is just looping date_time_now() and taking modulus out...
I am attempting to create an SPI communication to an ancillary circuit through an intermediary board and the nRF52840 USB dongle. If I start with the zephyr sample spi_flash...
Hi, I am starting from the following example: "Bluetooth Low Energy UART service sample", sdk version v2.6.0 I am trying to add a custom board (using VSCode NRF CONNECT extension...
ncs v2.9.0
peripheral_uart (nRF52840) modified code
central_uart (nRF52832) unmodified code
using power monitor for current consumption
When I send the packet from...
I want to update some data stored in UICR CUSTOMER area on an nrf52832.
Code to do this works fine, as long as the areas are already erased (0xFFFFFFFF).
However, if they...
Hi,
I'm doing a test with a test harness. An error occurs in test case TC-CNET-4.16. I would like to know how to solve this problem.
environment
・TH raspberry pi 4 Version...
Hello everyone,
I am currently facing the issue that migrating to NCS 2.9.0 is not possible as I get the following compile error:
Someone else had the same issue: Unfortunately...
Hello,
This morning I thought I would investigate the current consumption of some of the examples in the nRF connect SDK Fundamentals using the nRF9151DK and the PPK II...
Hi there,
Can you please help me with setup Platform independent driver from ST with Zephyr?
STMicroelectronics/lis2dh12-pid: lis2dh12 platform independent driver based...
Dear devzone, nRF54L15 runs private 2.4g, and needs to switch from 2400MHz to 2500MHz. How long is this period? How long is it to switch from 2400MHz to 2410MHz? I see from...
The chip I am using is 54l15, and the NCS version is 2.8.0
I used the peripheral_uart example for modification and got my own program, but I forgot which time this problem...
Hi Nordic
Asking this question to Nordic AI (right-down window), below was the answer.
The nRF9160 is a cellular IoT device, and its MTU size depends on the protocol...
