Hi:
I use ncs v2.8.0, using external flash(w25q128).
this is test flash project.
And this log:
Device_is_read returns a failure. But flash read/write successful...
Hello,
I wanted to verify if two devices are communicating by using a sniffer.
After running the radio_test example, I set up parameters for each transmitter and receiver...
hello, my code was built under ncs v2.6.0 and tool chain 2.6.0 without issue, I upgrade them to v2.9.0, then I get these errors, can not figure out how to fix them.
could...
Hi,
I'm new to fuel gauging and battery profiling and am trying to understand the process and the parameters used.
Is there a description of how a battery model is created...
Working to comply with EN 300 328 V2.2.2 by reducing Media Utilisation to <10% on my FHSS system. I've been told that over-the-air, the NRF24L01+ actually transmits 9 bits...
Securing your connected devices and their data in a cost-efficient way can be a challenge. There are, of course, standards for connectivity and communication, but what about injecting the necessary certificates…
Nordic's nPM1300 is a power management IC (PMIC) that is especially well-suited for SoCs like the nRF52 and nRF53 Series. Compared to the SoC's internal regulators, the PMIC is built on a larger 180…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…