Currently we are considering whether we should use external Flash Memory or NRF52 Internal Flash.
External Flash memory has a lot of drawback in comparsion with internal...
Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
Introduction
This example shows a simple GPIO driver for seamless handling of the GPIO and GPIOTE peripherals of the nRF52 series. This example is particularly intended for developers who wish to develop…
TL;DR
If you just want to navigate (without debugging) through the nRF5-SDK using CLion, follow the following steps. For debugging go to “Debugging the nRF52 with CLion” in the full post.
(optional…
Introduction:
This is a guide for the uninitiated, which I am most qualified to write. These tips cover the items I wish I had understood when I got my evaluation kits. Nordic support covered these…
This tutorial uses an outdated version of nRF Connect SDK. We recommend using the latest version of nRF Connect SDK when getting started with development. Please see academy…
Purpose
The purpose of this blog is to show how to create a Zephyr application that boots from the MCUBoot bootloader. We will also show how to update an application using the Device Firmware Update (DFU…
Scope
This is a discussion on building a Bluetooth application on our new nRF Connect SDK/Zephyr platform with the reflections to our nRF5 SDK which is based on the SoftDevice Bluetooth stack. The goal is…
The purpose of this document is to give a brief introduction to AWS services, and explain how to connect to these services using nRF9160 devices and the MQTT protocol. The tutorial covers the necessary…
Introduction
This document will go over the process of running a Mesh Provisioning Demo using the nRF Mesh app available on Google Play or iOS App Store from Nordic Semiconductor. There is a blog post…