I'm trying to use the ADC and internal reference to measure battery voltage on the nrf51422, while S210 is enabled.
From the example nrf51-ble-app-temp-master, I found...
I have Nokia Lumia 630 and it works well with nRF51822-EK but only with SDK nrf51822_v5.1.0.36092 and SoftDevice 6.0.0. Now I decided to try DFU OTA. I programmed bootloader...
Hello,
I found that there is a multiprotocol demo in folder Board\nrf6310\s110\experimental\ble_app_multiactivity_beacon,then I found it can implement concurrent connected...
Dear Sir
We got the problem on DFU upload firmware, it always failed in second DFU . We must unpair the device at iOS setting panel. Before next DFU.
Here is the log data...
Hi All,
My requirement is to read the data from nRF51822 device that is connected to a bluetooth and bluetooth is connected to a system using a .Net application.
I have...
Hi everyone,
I'm using the nRF51822 (pca10000 Dongle + pca10005).
My plan is to send one byte over the radio.
I tried to use the SDK-Example as a template but it's...
Hello
I have some problem that I want to change Characteristic UUID different from Service UUID.
Like,
Service UUID : 11111111 - 1111 -1111 -1111 -111111111111
Charcteristic...
Hi Nordic,
I used FDS to operate updata to update data more than 10K once, but there was an error. Hint FDS_ERR_RECORD_TOO_LARGE.Can FDS operate more than 10K data at once...
I want to create own android app with just nus service (uart).I'm not very good in android programming, so there are two ways for me doing that:
Use Android-nRf-uart...
Hey guys,
I have another question related to this example.
I've modified the UART example such that UART printing is disabled, and I am calling ble_nus_send_string(...
SDK 11.0.0
SD s132 2.0.1
nRF 52 dev kit
I have been in the process of adding dfu functionality to an existing application.
Currently, I have gotten the dfu to work...
Hi. I'm looking for streaming solution.
I think BT5 will be one of the great solutions.
I refered video as below.
www.youtube.com/watch
It shows that nordic chip...
Hello All,
I am working on one of the project using nRF51822 . in this project it requires multi communication protocols i.e i want to configure as below,
2xI2C
2xUART...
I currently have 2 redbear nrf51822 nano. I want to connect the UART of the nrf51822 to my arduino uno/nano but i dont know how i should do this. I tried looking for a solution...
Hello,
I am using PCA10040 and sdk12.2.2. I am trying to load ble_app_template code. But when I try to flash my code in pca10040 I am getting error as "No Jlink Device found...
