Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Hi,
I'm working on a project using a custom pcb with a 52832 chip. It has worked good for several months, but I got a Hard Fault during flashing today. Flashed it 3 times...
Hi team,
My customer is using Thingy52 for some prototype and they output some data from sensors, 2 questions:
1. What does the form of the data means as "6Q10 fixpoint...
Hi there,
Is there any certifications required for the newly developed product that is using nrf SDK and nrf52832 SOC and can we use bluetooth logo in that product?
...
Hi
I am trying to connect my nRF52832 DK with Raspberry Pi via BLE. I am able to discover the board on Pi, when bluetooth is turned on. However, I get an error on Pi saying...
Hi ...
i want to change the device name dynamically, i read my questions related to it , still not working . Here , gap_param_init i have set the flag to change the device...
To the kind attention of Nordic support team,
I have got a
1. PCA10040 board, with ble secured bootloader installed
2. PCA10056 that I usually work with every day, these...
Hi,
I'm using direct advertising in order to connect to mobile devices which were already connected to my nrf device. After the first connection, I save the mobile address...
Could it possible to reduce INIT and ADVERISE times ?
What is normal startup time for nrf52832 init peripheral for advertising?
What is the minimum possible advertising...
In the OPS register description, as well as in the files modules/hal/nordic/nrfx/mdk/nrf5340_application.h and nrf5340_network.h the HFCLKAUDIOALWAYSRUN register is incorrectly...
Hi Guys,
I'm looking for some information on how to get data from the secure side to the non-secure side of the firmware. We are building an NB-IoT GPS tracker which is...
Hi,
Is it possible to change the security option of characteristic read or write?
For example , we initial the characteristic as JUST_WORK? Then change it to SEC_OPEN...
I have adapted the " nrf52-mpu-easydma-using-timers-and-drivers " project from Github that I saw referenced in another post and have successfully modified it to work with...
Hi, We are using the heart rate example for developing our firmware, where we plan to send data out every 15 mins. But when we try to increase the advertisement interval beyond...
