Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Found the same problem:
https://devzone.nordicsemi.com/f/nordic-q-a/34160/light_switch-example-sdk-v2-0-1----problem-with-server
1) The server does not receive the address...
Hello. Complete n00b here!
I've built a small sample on mbed of an I2c Scanner. Also tried other runtimes. Somehow, its not working.
I'm using a GY-45 Module, which wraps...
Hi there
I tried to observe the message when DTM are working.
So I modify the example direct_test_mode to display on monitor.
But after modified , it comes out the error...
The nRF5 SDK references a field ble_adv_legacy_enabled in the ble_adv_config_modes_t structure (see http://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
nrf52832.
SDK14.2
Segger ES V3.34a
I am using sd_ble_gatts_value_get, in C file named ble_cus.c to retrieve the 'value' of a characteristic as written to by the...
Recently i am developing an application based on UART on nRF51822 platfrom, where an application receives the data through UART. During development, i went through nRF UART...
Hi,
We're using SR3 v1.1 for several BLE R/C.
Early this month, we received information of Engineering C Errata.
It suggests that we upgrade to SR3 v1.2 for fixing some...
Hi
I am writing a bootloader and am trying to get the start locations of the different memory segments e.g. the FLASH start segment from the flash_placement file.
On a...
Hello, I am developing a system where I have a app and a Rigado BMD-300 Module. I am using, for experiment, the nRF Connect App and in program, I use SDK 14.2 and s132 softdevice...
Hi to everyone,
sorry if this question will result stupid, but I'm really new on programming Nordic microcontrollers.
I'm trying to develop a simple ble application for...
1. Did secure BLE DFU first time for hrs app, BL jump to hrs app
2. Did secure BLE DFU second time for hts app, BL jump to hts app
3. Did nrfjprog HID keyboard app and...
Hello,
I am using NRF52840 board and SDK 14.1, Softdevice 5.0.0-2.
I am testing other devices on my board. However, it seems to work normally until 2, but the connection...
