Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I have created a build system that will install openmesh on simblee chips, and it appears to be mostly working. However, range is very poor, like max 2ft. I have tried adjusting...
Hi guys,
I am working with a central battery powered so, I am controlling the RF activity calling scan_start() or sd_ble_gap_scan_start() and disabling the RF activity...
Hello,
We are switching chips from the nrf51 to the nrf52832. I have a nrf52-DK board now. My Eclipse set up is still able to compile, run, and debug my nrf51 projects...
hi,
im a little lost with BLE at the moment. all i want to do is sending 3 bytes of data (sensor data) approximately 10 times (+- 5) a second (when the uC is not sleeping...
As a central, I am writing to a variable length characteristic, advertised by a service of my peripheral. In this case, I am sending 80 bytes of 0x01 as a test
uint8_t...
I used the ANCS program in sdk12.3.0, I have closed the white list function, I use the iphone connection and paired, then I ignore this device on the phone, and then I use...
Hi
I am using nrf51-dk board along with the S130. I am getting the following message when I debug my code. The central link count is set to 0 while peripheral link count...
Hello,
I didn't find much information about how different settings for the MTU size behaves with older versions of BLE devices. I'm using the softdevice s132 4.0.2.
...
When trying out the ble_app_hrs_freertos example in nRF5 SDK 11.0.0-2.alpha_bc3f6a0 , I seem to only get 14-character long device name announcements.
This happens when...
To @Hung Bui. Hello sir. I am new to NRF51 microcontrolers and I am trying to use Pstorage in my written code. I have noticed this post of your's:
I am using nrf51422...
Why do I call this bluetooth send function (ble_nus_string_send )return values is 04 not 00(return sd_ble_gatts_hvx), why will appear this kind of circumstance?When I send...
I am using nRF Connect with nRF52 and need to use UART over BLE to send command to the device but I find that you can only use hexadecimal input and get hexadecimal output...
