But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello,
I'm trying to port an Eclipse project template that I have set up for the NRF52 using SDK 13. I want to downgrade the SDK to v12.3 in order to be able to use the...
Hi! For a custom board, I have my app working ok. So I wanted to add the dfu secure bootloader to my project. I Had no problem to do that, both app and bootloader start ok...
Hi
Why does making an input differential lose a bit on the nRF52. According to the data sheet, if a channel is 10 bit and using 0.6V reference and gain 1 and input is 100mV...
Hello.
I am trying to port bootloader project from SDK to SES. But I do not know how to write data to UICR.
Steps what I've done:
My nRF52832_xAA_MemoryMap.xml looks...
Hi, I was trying to test the CTS example with a PCA10040 board.
I use
Nordic's SDK 14.0
64-bit Windows 10 machine (the PCA10040 is connected to this machine...
In nRF5_SDK_14.0.0_3bcc1f7\components\libraries\usbd\app_usbd.c
if APP_USBD_CONFIG_LOG_ENABLED is put at 1, the compilation fail. It is solved by adding NRF_LOG_MODULE_REGISTER...
when i use sd_ble_gatts_hvx() send data to ble stack, after 300ms later ,i get the ble stack event BLE_EVT_TX_COPLETE , how i can reduce the time(300ms), let the data send...
how i can send data 1500byte per second，use the sd_ble_gatts_hvx(). because i send the first package use sd_ble_gatts_hvx() and 300ms later i get the BLE_EVT_TX_COMPLETE,...
