Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
I would like for the nodes in the network to be able to talk to any other node, even if the other node address are not pre-configured.
For example, I would like to be able...
Hi, Nordic
Now I have one nRF24LU1P USB Dongle, if sometimes there is no data in/out usb(maybe 3ms), USB Dongle will enter suspend state.
Can USB Dongle support to resume...
I am building the ble_app_hrs_freertos example code for a pca10040 dev board located in the SDK 12.2 at: nRF5_SDK_12.1.0_0d23e2a/examples/ble_peripheral/ble_app_hrs_freertos...
Hello guys,
I'm working in a project which requires from me to bond to certain devices and refuse the bonding from others, I mean at certain input, connect to anyone and...
Can I expect the call to sd_flash_erase() to successfully erase a page of flash while I have an ANT channel open doing a low priority search?
What about when doing a BLE...
Hi there,
Is it possible to use TWI0 and SPI0 (or TWI1/SPI1) time multiplexed?
When enabling them both in sdk_config.h I get "Error: L6200E... IRQHandler multiply defined...
Hi guys,
I'm having some trouble with an spi flash memory (AT45DB081D) I interfaced on my nrf51 DK.
I used the spi master code of nRF5 v.12 SDK as base. I'm using gcc...
Hi,
I try to using nrfjprog to burn softdevice + bootloader + applacation, but it shows that application burn failed.
My SDK version is nRF5_SDK_12.2.0_f012efa and...
I'm using GCC 5.3 on Windows 10 64 bit. The linker is successfully opening nfc_t4t_lib_gcc.a, but is failing with undefined references to functions declared in nfc_t4t_lib...
Hello!
I have a device with custom nrf52832 board.
This device can beep using buzzer. Frequency of the sound is generated by pwm driver from SDK. I'm changing frequencies...
Hi, i read here, that softdevice 7 has a bug and the beacon firnware drawing too much current. I measured 1mA.
So, i looked out for a precompiled set that works fine.
I...
