Hi,
I'm using the nRF52833 to develop a BLE beacon and built a Bluetooth gateway for my application.
Application Requirements:
The beacon should advertise using...
Hello,
I want to perform some antenna measurements and compare the rf performance of my custom PCB with an nrf9160 SiP with the nrf9160 dk.
To perform some antenna measurements...
Hello - I have the exact same question as proposed in this thread - I am wondering if there has been any change in the 3 last years since it was posted.
In a nutshell, we...
Hi I want to build a multi role BLE device.
As a peripheral it shall stream ADC data with arounf 20 kbytes per second.
As Central it shall receive adv_nonconn_ind packets...
Hi,
Hope you are doing well.
I would like to use eSIM on nRF9151-DK board and an eSIM has been assembled in the board. However, eSIM is not detected.
According to...
Dear Nordic Engineers
I developed a PWM function to drive the RGB LED. Then I found a problem, which is w hen I used a PWM signal of one channel to control the RED light...
I get error provisioning key on nRF54L15 and NCS 3.0.1. I tried using "Erase all" in nRF connect SDK Programmer, but it doesn't help. Please check also the attached log. nrf54l15dk...
Hi,
I am currently working on a prototype with Silicon Labs Thunderboard sense. I am looking for a replacement product that has NRF BLE module. All I need is a BLE module...
Does the S110 v7.0.0.3-alpha DFU bootloader support nRF51822XXAB (128k) part?
I'm trying to flash the DFU bootloader on my custom PCB that contains a nRF51822XXAB part...
Hello
I have an application to process advertising report even if it is duplicated.
Is there any way to control whether the soft deice shall filter
duplicate advertising...
Hello,
I am using the example "ble_app_beacon", I have compiled and tested (all works well).
I am wanting to add more data to the scan response by passing more data to...
I'd like to run a softdevice application with OTA support on a RIGADO BMD-200 Evaluation board . I've successfully flashed the softdevice, the app, and the rigado bootloader...
I have a simple application which pretty much consists of the following main function:
int main(void)
{
SOFTDEVICE_HANDLER_INIT(&clock_lf_cfg, NULL);
ble_enable_params_t...
Hi,
We're working on BLE communication between iOS and 51822 and found a data reliability issue. We have a custom characteristics that iOS read 60 bytes data from 51822...
Hi,
I have made some changes with how we update tick timer inside FreeRTOS and the results are promising
.
The improvement is
RTOS tick will auto correct if masked...
I went through a similar post for nrf51 which explains the numbers pretty well ( devzone.nordicsemi.com/.../) . I wanted to know what the values are for nrf52. The internal...
We have a nrf51822 device that has to send 6 bytes back to back at 12K8 and 6-18 bytes at 38K4 in the future.
The bytes are in an array and do not need to be generated...
Hi experts,
I have just tried lbs example. I saw in the ble_lbs_c.h, the base uuid and service uuid are defined for the peripheral peers who are going to be connected....
I'm developing with nRF52, SDK 12.2 and softdevice s132 3.0.0 . I modified the saadc_ble code from github which uses SDK 11.0. It seemed to work fine. But disconnection happens...
Hi,
I adapted the ble_app_multilink example to continuously scanning for ibeacons and collecting rssi data.
Data are then sent via UART to a microcontroller which provides...
