Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Dear community, we're having trouble connecting our thingy91x to the BMI270 via the nRF5340 using SPI. We've tried many similar cases without success. Here's our setup: Visual...
Hi,
I'm using littlefs with an external flash. Everything works well, but if I look my parition manager I have a 24KB little storage automatically created
is it possible...
Hi,
I have developed a custom application on nRF54L15 and now I want to add OTA over BLE support in it.
For that, I am following Exercise 5 – FOTA over Bluetooth Low Energy...
I am trying to setup the dev. environment in OpenSuSE Linux, but, even though it says Linux, I only find support for Ubuntu.
I am blocked now setting connecting the board...
Hello,
I'm designing an application where I intend to authorize different users to access the functionalities of a device based on the nRF54 family.
The general idea is...
Hello, I'm using NFC Type 4 Tag (T4T) but I can't write to it. The tool I'm using is the nRF NFC Toolbox. From the app screen I generate a Record and then touch the tag to...
Good day, I'm trying to use pin 1.02 as a GPIO in a TF-M build using a (custom) non-secure board target, and I'm struggling to find the appropriate way to accomplish this...
When I first created the BLOB Transfer model, I had to analysis the DFU sample code because there was no BLOB Transfer model sample.
Is it possible for me to create a sample...
Hi, For supporting multiple different peripherals is it possible to get something back from a SoC observer which indicates the peripheral type? https://docs.nordicsemi.com...
We have a manufacturing project assembling the 0.35mm CSP package. We would like guidance on part handling, solder stencil specifications and any other process steps that...
I am developing a DFU (FOTA) feature via BLE on the nRF54L15 MCU using NCS v2.9.1 .
I am using MCUBoot direct-XIP with revert mode .
My application needs to detect the...
Hi Nordic Team,
I’m working with the nRF9160DK , specifically targeting the nRF52840 application core ( nrf9160dk_nrf52840 ).
While building a BLE Central application...
Hi Nordic team,
We’ve implemented a custom firmware update flow for our nRF5340-based device , which supports a robust single-image FOTA process using external NAND flash...
In our design, we wired the SD card in SPI mode on SPI bus 4 wich a maximum SPI frequency of 50 MHz or 25 MHz as these are supported by the SD card. We used FAT32 file system...
Due to board design flaws that led to insufficient rise time for 100kbps communication, I would like to configure my i2c node in the device tree with a baud rate of 10 kbps...
